Warning: This option MUST only be run when there are no other users within the Workshop Loading module. If run with users on the system, it is possible that data files will be damaged.
The Reset in use flags form is displayed when you select the Reset In Use Flags option from the WL SYSTEM MAINTENANCE MENU.
From time to time, a user may exit from the Workshop Loading module illegally, either through a power failure, or by turning off a terminal whilst still logged into the module, or due to some other hardware or software fault. If this happens then any files which the operator had open at the time will still be registered as in use. When a 'stand-alone' routine is required to be run, it checks first of all that none of the affected files are being used by another operator. In this sort of situation it is possible that the program will think that certain files are still being used when in fact they no longer are.
Should this situation arise then you should verify the situation by using the Prevent/allow access program to display who the current users are and clear any illegal users. Once this has been done, you should then run the reset in use flags program to correct the situation, which will access each of the files and reset the 'in-use' flag.
BUTTONS:
Exit: Returns you to the WL SYSTEM MAINTENANCE MENU.
Help: Displays help on the application using the default browser.
Reset: Reset all the In Use Flags.
Company: Reset the In Use flags for a particular Company.
Note: This option will normally be run automatically by the Timed operations schedule.
